You can put a washer dryer in a NYC apartment only if your building allows it, and many do not. Co-ops, condos and rentals all set their own rules, and most require written approval, a drain pan, a leak sensor and an automatic shutoff valve. Physically, you need a 2 inch drain, hot and cold water, the right power, and either a vent to the outside or a ventless heat pump dryer. A stacked pair in a closet with new plumbing and electrical runs about $7,000 in NYC per Brick Underground, before board fees.
Can I put a washer dryer in my NYC apartment?
Start with your building, not the appliance store. Brick Underground reports that many NYC rentals, co-ops and condos prohibit in unit machines entirely, and others allow them case by case. CityRealty notes that some large prewar co-ops have grandfathered machines but cannot take any more, because the plumbing and electrical were built for a world without them.
The plumbing concern is real. The NYC Plumbing Code even has a section on suds pressure zones (Section 704.6), the spots in a shared stack where detergent foam from upper floor machines collects, which the code requires lower floor fixtures to be piped around. Brick Underground adds that older buildings may have undersized or clogged waste lines that back up into neighbors' units.
Co-ops: the proprietary lease and house rules
In a co-op, look in two places: the proprietary lease and the house rules. Many house rules ban washers and dryers outright or require the board's written consent. Courts generally back boards on this. In a case summarized by Smith, Gambrell and Russell, a co-op adopted a house rule banning in unit washers and dryers because of inadequate plumbing. A shareholder installed a new machine without permission, it flooded her apartment, and the court applied the business judgment rule, found her in default and ordered her to remove it. Habitat magazine quoted a co-op attorney saying a board acting in good faith could ban washing machines altogether.
If your co-op allows them, approval usually runs through the alteration agreement, with plans and the board engineer's review.
Condos: bylaws, rules and the alteration agreement
In a condo, laundry is governed by the bylaws, house rules and the building's alteration process, and Brick Underground notes many condos prohibit in unit machines too. Expect the same approval steps and conditions as a co-op. Read the rules before you buy if in unit laundry matters to you.
Rentals: the lease decides
Renters need the landlord's written consent. Many leases have a rider banning washers. In Brick Underground's Ask Altagracia column, an attorney explains that a landlord who finds one typically serves a notice to cure, giving 10 days to remove it (plus five when mailed), and can start an eviction case if you do not. Rent stabilized tenants have extra protection, but the safe path is to ask first.
What conditions do boards attach?
When a building says yes, Brick Underground lists the usual conditions:
- A drain pan under the washer
- An overflow sensor and an automatic water shutoff valve
- In some buildings, a waterproof membrane under the finished floor that extends at least six inches up the walls
- Sound isolating pads or underlayment
- Placement in or next to a wet room under the wet over dry rule, usually the kitchen, a bathroom or a closet beside one
Some buildings relax the location rule if you add waterproofing, leak detection and shutoff valves.
Vented vs ventless dryers
This is the choice that decides whether many installs are possible at all.
Vented dryers blow hot, wet air outside. The NYC Mechanical Code requires dryer exhaust to go to the outside of the building through its own duct. For a domestic dryer, the duct is limited to 35 feet, reduced for every elbow, unless the manufacturer's instructions allow a different length. The flexible connector behind the dryer cannot be longer than 8 feet or hidden inside a wall, and a closet built for a dryer needs a makeup air opening of at least 100 square inches. In a high rise apartment far from a window, those rules often make a vented dryer impractical. If the building is landmarked, a new vent through the facade also needs an LPC permit, because interior work that affects the exterior requires one.
Ventless dryers keep the air inside a closed loop and drain the water. The Mechanical Code exempts listed and labeled condensing (ductless) electric dryers from the exhaust rules. There are two kinds:
- Heat pump dryers reuse heat instead of making it with an element. ENERGY STAR says they can cut energy use by at least 28 percent compared with standard dryers and can go in any room with electricity and water.
- Condenser dryers use a heating element and cool the air to pull the water out. They are also ventless.
For most Manhattan apartments, a ventless heat pump dryer or an all in one heat pump combo is the easiest thing to get approved, which Brick Underground also recommends.
| Type | Vent needed | Power | Notes |
|---|---|---|---|
| Standard electric dryer | Yes, to outside | Usually 240 volt (Brick Underground) | Hardest to approve in apartments |
| Gas dryer | Yes, to outside | Gas line and power | New gas piping needs a permit; Brick Underground expects boards to refuse new gas dryer lines |
| Compact heat pump dryer | No | Some models run on 120 volt, 15 amp, such as the Miele TWD360WP | Condensate drains by hose to a sink or drain |
| All in one heat pump combo | No | Some models plug into a 120 volt outlet, such as the GE Profile UltraFast Combo | One machine, so you cannot wash and dry two loads at once |
Check the installation guide for your exact model. Voltage, amperage and clearances differ, and some ventless models still need 240 volts. Miele's larger PDR908HP heat pump dryer, for example, is listed at 240 volts and 30 amps.
Drain, water and electrical requirements
The NYC Plumbing Code sets the basics for the washer:
- Drain. The washer discharges through an air break into a standpipe or a laundry sink. The trap and fixture drain must be at least 2 inches, and the drain must connect to a 3 inch or larger branch, building drain or stack (Section 406.2).
- Standpipe height. A standpipe must rise at least 18 inches and no more than 42 inches above the trap weir (Section 802.3.3).
- Water supply. The supply must be protected against backflow by an air gap built into the machine or a backflow preventer (Section 406.1).
Electrical needs depend on the machines. A standard electric dryer typically needs a 240 volt outlet, which Brick Underground notes can be hard to add in older buildings. Your building may ask for a load letter showing the apartment's service can handle the new load.
Do you need a DOB permit for a washer dryer?
Usually, for at least part of the job. Plumbing has to be done by a licensed master plumber, and new electrical circuits need a DOB electrical permit pulled by a licensed electrician. Brick Underground says gas and electrical work needs a final DOB inspection, and that altering a closet or plumbing lines may need additional permits.
Whether new washer hookups need a full plumbing permit or can be recorded as ordinary plumbing work depends on the scope, and that rule changed in 2026. See do I need a permit to renovate my NYC apartment for the current limits, and have your plumber confirm the filing for your job.
How much does it cost to install a washer dryer in a NYC apartment?
Costs split into the machines and the installation. These are published market figures, not quotes.
| Item | Published figure |
|---|---|
| All in one combo | $1,600 to $3,000 (Brick Underground) |
| Compact stacked set (Bosch) | $2,897 to $5,077 (Brick Underground) |
| Miele stacked machines | About $4,000 and up (Brick Underground) |
| Stacked pair in a closet with new plumbing and electrical, NYC | About $7,000 (Brick Underground) |
| New hookups near existing lines, national | $350 to $600 (Thumbtack) |
| Hookups from more distant lines, national | $700 to $2,000 (Thumbtack) |
| New 240 volt dryer circuit, national | About $500 average (Thumbtack) |
The national numbers and the NYC number disagree, and the gap makes sense. National figures assume a house with easy access. A Manhattan install adds licensed trades, permits, a drain pan and shutoff valve, possible floor waterproofing, building insurance requirements, freight elevator time and restricted work hours. If laundry is part of a larger kitchen or bathroom renovation, much of that cost is shared with work you are already doing.
In Jersey City and Hoboken condos, the condo association's rules and the local construction code office replace the co-op board and DOB. Our Jersey City and Hoboken condo guide covers that process.
If you are planning a renovation and want laundry in it, Euro Restoration's design specialists plan the location around your building's rules from the start, and the price is fixed before work begins. See how a full apartment renovation works.
Frequently asked questions
Is it illegal to have a washer and dryer in a NYC apartment?
The restrictions most people run into come from the building, not the city: the proprietary lease and house rules in a co-op, the bylaws and rules in a condo, or your lease in a rental. Installing one without approval can lead to fines, forced removal or, for renters, an eviction case.
Do I need a vent for a dryer in my NYC apartment?
Only for a vented dryer, which must exhaust to the outside under the NYC Mechanical Code. Listed condensing (ductless) electric dryers, including heat pump models, are exempt from that rule.
Can a washer dryer plug into a regular outlet?
Some can. Certain compact heat pump dryers and all in one heat pump combos run on 120 volts. Standard full size electric dryers usually need a 240 volt circuit. Check the spec sheet for your model.
Where can a washer dryer go in a NYC apartment?
Usually in or next to a kitchen or bathroom, over wet space in the unit below. Boards rarely allow laundry over a neighbor's bedroom or living room without extra waterproofing and leak protection.
How much does it cost to add a washer dryer to a NYC apartment?
Brick Underground puts a stacked pair in a closet with new plumbing and electrical at about $7,000, and combo units alone at $1,600 to $3,000. Board fees, waterproofing and permits can add more.